Register Plate made from 1.5mm thick galvanised steel, it can be sprayed to match the colour of your stove pipe. Comes 4 angle supports. Can be cut down on site.
Friday, 25 November 2011
Register Plate (C) 1250mm x 600mm
Register Plate made from 1.5mm thick galvanised steel, it can be sprayed to match the colour of your stove pipe. Comes 4 angle supports. Can be cut down on site.
Register Plate (B) 1000mm x 400mm
Register Plate made from 1.5mm thick galvanised steel, it can be sprayed to match the colour of your stove pipe. Comes 4 angle supports. Can be cut down on site.
Register Plate (A) 800mm x 400mm
Register Plate made from 1.5mm thick galvanised steel, it can be sprayed to match the colour of your stove pipe. Comes 4 angle supports. Can be cut down on site.
Chimney Notice Plate
The Chimney Notice Plate :
Chimney Notice plates are a Building Regulations requirement. They most be filled out and fixed near to the appliance or within a meter cupboard.
Aluminium Tape
50mm(2 inch) wide, 50 metres long aluminium tape with a temperature range from -10 degrees centigrade to 100 degrees centigrade.
The Rockwool Insulation Tubes 125mm
Manufactured from non-combustible rock wool. It does not sustain vermin and will not encourage growth of fungi, mould or bacteria and is suitable for continuous operating temperatures of up to 500 degrees centigrade. You must use the foil tape for all joints. Pipe thickness is 25mm (1 inch) and lengths are 1000mm (39 inches). Comes in three diameters for the following liner sizes 140mm (to suit 125mm ( 5 inch )), 169mm ( to suit 150mm ( 6 inch )) and 219mm ( to suit 200mm ( 8 inch )). The 219mm diameter can easily be trimmed to fit 175mm (7 inch) chimney liner. (Not suitable for class 2 flexible liner).
The Vermiculite (100L Bag)
The Vermiculite (100L Bag) :
For insulating solid fuel and wood burning liners, it reduces the amount of condensates by keeping the flue warm, it also holds the liner rigid to aid sweeping.
Joiner 125mm (5 inch)
The Joiner 125mm (5 inch) :
Allows the joining of two pieces of multi fuel liner (only to be used in none flueing applications).
The Gather Hood 300mm x 300mm Base
Gather hoods are used on open fires and baskets. The formed stainless steel gather is connected to the multi fuel liner in the chimney. The gather helps the flow of gases up the chimney, it also prevents the liner coming into contact with a fierce heat that can be produced.
The Nose Cone 125mm (5 inch)
The Nose Cone 125mm (5 inch) :
The nose cone is attached to the leading end of the liner, it helps prevent snagging against the side of the stack during installation. Please note that draw cords are not supplied.
Subscribe to:
Posts (Atom)